This website or its third party tools use cookies, which are necessary to its functioning and required to achieve the purposes illustrated in the cookie policy. If you want to know more or withdraw your consent to all or some of the cookies, please refer to the cookie policy. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies..

16-fold binary output / 8-fold blind actuator FF1

16-fold binary output / 8-fold blind actuator FF1

16-fold KNX binary output 16(10)A for switching and control of loads or 8-fold KNX actuator for control of drives for motorized blinds, shutters or curtains. Mounting in distribution board on EN 60715 rail (8 modular units, each 18 mm). To be used in KNX installations for home and building automation.

• ON/OFF switching of individual loads or groups of loads
• Configurable as normally open or normally closed switch
• Logical gates and forced mode for each channel
• Manual control by membrane pushbuttons
• Status feedback of output channels through LEDs
• Switching pushbutton manual/automatic mode
• Block function for each channel
• Time scheduling: switching delay for on and off, staircase lighting function with warning signal
• Integration in scenarios
• Operating hours counter configurable via bus

• Full up and down run
• Partial run with stop position from 0 to 100% of the length of the run
• Position setting (change during the operation of the preset position)
• Adjust the inclination of the slats (for blinds)
• Integration in scenarios
• Automatic control for protection against direct sunlight
• Automatic control for protection against weather conditions (rain, wind, frost)
A detailed description of the parameters can be found in the application manual of the device. Configuration and commissioning require ETS4 or later versions. ETS application program: APEKFF1TP##.knxprod (## = release). Available languages: English, French, German, Italian